resolved
shinasha
offlineMember
Thanks for the great distro! I'm really enjoying slitaz.
I do not see eth0 as an interface. Running ifconfig I see only lo, and previously dummy0 but that has disappeared.
# dmesg | grep -i eth0
returns nothing
# uname -a
Linux slitaz 2.6.37-slitaz #2 SMP Wed Mar 7 10:36:39 CET 2012 i686 GNU/Linux
# lspci -nn | grep -i eth
14:00.5 Ethernet controller [200]: JMicron Technology Corp. JMC260 PCI Express Fast Ethernet Controller [197b:0260] (rev 02)
Thank you for your help.
mojo
offlineKey Master
Your ethernet requires CONFIG_JME : http://cateee.net/lkddb/web-lkddb/JME.html
Slitaz-4.0 :
tux@slitaz:~$ zcat /proc/config.gz | grep -i CONFIG_JME
# CONFIG_JME is not set
You can either recompile the kernel to enable jme as a module or builtin support, or compile the manufacturers driver. In either case you'll need to install slitaz-toolchain and linux-source.
Tutorial on kernel compile: http://doc.slitaz.org/en:guides:kernel
shinasha
offlineMember
I finally managed to recompile the kernel with the JME driver built in:
zcat /proc/config.gz | grep -i CONFIG_JME
results in CONFIG_JME=y
My plan was to do it in a virtual machine so I had internet access, then create an iso based on that. Every time I try to do that using Tazlito, the new iso does not have JME enabled after install. My numerous attempts with Tazlito, I believe, have just recreated an iso with the default kernel. This isn't very descriptive but I have tried so many different things I don't know where to start. This is way beyond my linux experience but I'm having fun reading the documentation and trying new things. Just need a bump in the right direction. Thanks again.
You must log in to post.
