Hi, I wonder if there is a manual or tell me how to install "SliTaz 4.0-RC3" and "grub" through the console mode.

help, Install "SliTaz 4.0-RC3" in console mode
(5 posts) (2 voices)-
Posted 13 years ago #
-
Frugal Install with grub
tazusb: http://hg.slitaz.org/tazusb/raw-file/tip/doc/tazusb.en.html
Full Install with grub
tazinst : http://hg.slitaz.org/slitaz-tools/raw-file/6e8c38a0aee3/doc/tazinst.en.htmlFrom console:
tazusb usage
tazinst usageDo not use fat32 or NTFS filesystems on full install partition or for /home partition, only linux ext3 filesystem.
Posted 13 years ago # -
Posted 13 years ago #
-
You have to manually configure the Slitaz installer setup file /var/lib/tazinst.conf
#nano /var/lib/tazinst.conf
The setup file is well commented with examples.
http://hg.slitaz.org/slitaz-tools/raw-file/6e8c38a0aee3/doc/tazinst.en.html : SETUP FILE
Finish and save tazinst.conf in nano, run tazinst check /var/lib/tazinst.conf
After tazinst check validates tazinst.conf, your ready to install.
#tazinst install /var/lib/tazinst.confPosted 13 years ago # -
and I did well, it was my fault that I read the wrong manual command.
thanks for the help
Posted 13 years ago #
Reply
You must log in to post.