Hi guys, I have a problem to mount old yashica ez5030 digital camera on usb.
Have tried slitaz4 slitaz5rc1 slitaz-cooking, but not succesfull. The same camera on windows it revealed as drive external without any optional driver.
This is the result of dmesg on my tests
on slitaz5-rc1
usb 3-2: new full-speed USB device number 2 using uhci_hcd
scsi6 : usb-storage 3-2:1.0
scsi 6:0:0:0: Direct-Access 5MP-CARD 1.00 PQ: 0 ANSI: 0 CCS
scsi 6:0:0:1: Direct-Access 5MP-CAMERA 1.00 PQ: 0 ANSI: 0 CCS
sd 6:0:0:0: Attached scsi generic sg2 type 0
sd 6:0:0:1: Attached scsi generic sg3 type 0
sd 6:0:0:1: [sdc] 27073 512-byte logical blocks: (13.8 MB/13.2 MiB)
sd 6:0:0:1: [sdc] Write Protect is off
sd 6:0:0:1: [sdc] Mode Sense: 00 00 00 00
sd 6:0:0:1: [sdc] Asking for cache data failed
sd 6:0:0:1: [sdc] Assuming drive cache: write through
sd 6:0:0:0: [sdb] Attached SCSI removable disk
sd 6:0:0:1: [sdc] Asking for cache data failed
sd 6:0:0:1: [sdc] Assuming drive cache: write through
sdc: sdc1
on this case have tried to manual mount sdc1, but no work, it freeze
on slitaz-4
usb 3-2: new full speed USB device using uhci_hcd and address 2
scsi4 : usb-storage 3-2:1.0
scsi 4:0:0:0: Direct-Access 5MP-CARD 1.00 PQ: 0 ANSI: 0 CCS
sd 4:0:0:0: Attached scsi generic sg1 type 0
sd 4:0:0:0: [sdb] Attached SCSI removable disk
same slitaz-4 but kernel 2.6.37 recompiled for me
usb 3-2: new full speed USB device using uhci_hcd and address 4
usb 3-2: New USB device found, idVendor=143c, idProduct=3005
usb 3-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
usb 3-2: Product: 5MP Digital Camera
usb 3-2: Manufacturer: 5MP Digital Camera
usb 3-2: SerialNumber: 012346
scsi6 : usb-storage 3-2:1.0
scsi 6:0:0:0: Direct-Access 5MP-CARD 1.00 PQ: 0 ANSI: 0 CCS
sd 6:0:0:0: Attached scsi generic sg1 type 0
sd 6:0:0:0: [sdb] Attached SCSI removable disk
anyone have a trick to put on kernel config?