llev - thanks again.
/etc/network.conf
# /etc/network.conf: SliTaz system wide networking configuration.
# Config file used by: /etc/init.d/network.sh
#
NETWORK_CONF_VERSION="2"
# Set default interface.
INTERFACE="eth0"
# Dynamic IP address.
# Enable/disable DHCP client at boot time.
DHCP="yes"
#
# Settings only for static IP address.
#
# Enable/disable static IP at boot time.
STATIC="no"
# Set IP address and netmask for a static IP.
IP="192.168.0.8"
NETMASK="255.255.255.0"
# Set broadcast address
BROADCAST="192.168.0.255"
# Set route gateway for a static IP.
GATEWAY="192.168.0.1"
# Set domain name
DOMAIN=""
# Set DNS server for a static IP.
DNS_SERVER="192.168.0.1"
#
# Wi-Fi settings.
#
# Enable/disable wireless connection at boot time.
WIFI="no"
# Set "yes" if you don't want to store networks you're already connected.
WIFI_BLANK_NETWORKS=""
#
# Wi-Fi settings for iwconfig.
#
# Wi-Fi interface. It can auto-search interface if value below is fail.
WIFI_INTERFACE="wlan0"
# WPA driver; default is "wext" (Wireless Extension).
WIFI_WPA_DRIVER="wext"
# Set the operating mode of the device. The mode can be "Ad-Hoc", "Managed",
# "Master", "Repeater", "Secondary", "Monitor" or "Auto".
WIFI_MODE="Managed"
# Set the operating channel in the device. Empty by default.
WIFI_CHANNEL=""
# Force the card to register to the Access Point given by the address, if it's
# possible. Empty by default to automatic mode.
WIFI_AP=""
#
# Wi-Fi settings for wpa_supplicant (for given network).
#
# SSID (network name)
WIFI_ESSID="grd"
# BSSID (optional), use this block to associate with the AP
WIFI_BSSID=""
# Wi-Fi security. Empty ("") for open network; "ANY" for trying many methods;
# "WEP" for WEP; "WPA" for WPA/WPA2-PSK; "EAP" for 802.1x EAP.
WIFI_KEY_TYPE="WPA"
# Password for WEP, WPA, EAP, WAPI, and ANY; both in ASCII or HEX form.
WIFI_KEY="********"
# Method for EAP: "PEAP", "TLS", "TTLS", "PWD".
WIFI_EAP_METHOD=""
# File path to CA certificate file (PEM/DER).
WIFI_CA_CERT=""
# File path to client certificate file (PEM/DER).
WIFI_CLIENT_CERT=""
# Identity string for EAP.
WIFI_IDENTITY=""
# Anonymous identity string for EAP.
WIFI_ANONYMOUS_IDENTITY=""
# Inner authentication parameters: "", "PAP", "MSCHAP", "MSCHAPV2", "GTC".
WIFI_PHASE2=""
/etc/wpa/wpa.conf
network={
ssid="HP-Print-36-LaserJet 200 color"
scan_ssid=1
network={
ssid="xfinitywifi"
scan_ssid=1
network={
ssid=""
scan_ssid=1
key_mgmt=NONE
priority=2
}
network={
ssid="grd"
scan_ssid=1
psk="********"
key_mgmt=WPA-PSK
priority=3
}