I would like to run Slitaz 3 on my Panasonic cf-28 which has a P3 Pentium @ 600 MHz. The screen has a 2 inch boarder all around and the desktop does not fill the screen. The graphics chipset is silicon motion lynxEM. I searched and found some old posts about similar problems but I couldn’t understand them. Can someone enlighten me in an easy step by step way if it is possible to get the graphics to work properly.
Thanks in anticipation.
In case you’re wondering Slitaz 4 and rolling will not load at all. 3 works fine other than this screen issue.
silicon motion lynxEM
(1 post) (1 voice)- Started 3 years ago by terrybull
- This topic is not a support question
-
terrybull
offlineMemberPosted 3 years ago #
Reply
You must log in to post.
