You are not logged in.
содержание /etc/wvdail.conf
[Dialer Defaults]
Init3 = AT+CGDCONT=1,"IP", "internet"
Modem Type = USB Modem
Stupid Mode = 1
Phone = *99***1#
Username = gdata
Password = gdata
Modem = /dev/ttyUSB0
Baud = 115200
New PPPD = yes
Ask Password = 0
Idle Seconds = 0
еще немного дополнительной информации:
компьютер - lenovo S10-2
модем - huavei E1550 куплен в МТС (разлочен под других сотовых операторов)
провайдер - Мегафон
Offline
Вроде без косяков.
По скринам - модем определяется нормально и отвечает на команды. Вопрос только в настройках APN и пароль/логин. Всё что могу посоветовать - звякнуть оператору, вызнать их и прописать.
Offline
А чем плох метод описанный здесь - http://doc.slitaz.org/ru:guides:dialup )) ? У меня все отлично настроилось, модем E1820 мегафон, единственное пришлось перевести модем в режим "только модем", поскольку он иначе не обнаруживался.
Offline
метод описаный в http://doc.slitaz.org/ru:guides:dialup у меня не сработал
вот что пишет система в ответ на tazhw setup 3g-modem
COMMAND OPTIONS: 3g-modem cat
installing pkg: linux-dialup
================================================================================
Last packages.list is ready to use. Note that next time you recharge the list,
a list of differences will be displayed to show new and upgradeable packages.
Unable to find : linux-dialup in the mirrored packages list.
Unable to find : get-linux-dialup in the mirrored packages list.
installing pkg: wvdial
================================================================================
Last packages.list is ready to use. Note that next time you recharge the list,
a list of differences will be displayed to show new and upgradeable packages.
Unable to find : wvdial in the mirrored packages list.
Unable to find : get-wvdial in the mirrored packages list.
installing pkg: usbutils
================================================================================
Last packages.list is ready to use. Note that next time you recharge the list,
a list of differences will be displayed to show new and upgradeable packages.
Unable to find : usbutils in the mirrored packages list.
Unable to find : get-usbutils in the mirrored packages list.
installing pkg: hal-info
================================================================================
Last packages.list is ready to use. Note that next time you recharge the list,
a list of differences will be displayed to show new and upgradeable packages.
Unable to find : hal-info in the mirrored packages list.
Unable to find : get-hal-info in the mirrored packages list.
==========================================================
Due to a lack of compatible hardware for troubleshooting,
this 3g-modem device has not been properly tested. Please
report any success, failure, bug to SliTaz Labs or Forums.
==========================================================
Detected PCI devices Kernel modules
================================================================================
> Module in use: snd_intel8x0
> Module in use: yenta_socket
> Module in use: yenta_socket
================================================================================
Detected USB devices Kernel modules
================================================================================
================================================================================
====================================
list detected devices
======================================
Failed to setup 3g-modem
======================================
Offline
вот бы добавить в slitaz классную прогу под названием NetworkManager
только как это сделать?
Offline
http://forum.slitaz.org/topic/read-this-if-you-use-a-3g-modem-to-connect#post-9191
Offline
[ Generated in 0.017 seconds, 7 queries executed - Memory usage: 1.54 MiB (Peak: 1.77 MiB) ]