SliTaz Forum

Additional network card

(4 posts) (3 voices)

• Started 12 years ago by ntzanos
• Latest reply from nikea
• This topic is resolved

Tags:

No tags yet.

1. 

   ntzanos
   

   offline

   Member

   Hi,

   I have installed Slitaz 4 on a VirtualBox VM. I would like to setup two network cards, which is something I usually do when I want host-only interface for ssh connection and a NAT connection for the internet.
   I tried with various ways, but I have not yet succeeded. Is this possible at all?
   I see that in /etc/network.conf there is a default device declared, but how do I declare additional ones?

   Regards,

   Nikos Tzanos

   Posted 12 years ago #
2. 

   mojo
   

   offline

   Key Master

   Find network card alias:
   cat /proc/net/dev

   Activate network card:
   ifconfig <network card alias> <i.p. address> up

   Activate network card on boot: add command to /etc/init.d/local.sh

   Posted 12 years ago #
3. 

   ntzanos
   

   offline

   Member

   Thanks a lot for the info.

   Posted 12 years ago #
4. 

   nikea
   

   offline

   Member

   If the card take the address by dhcp , you could add the dhcp command in /etc/init.d/local.sh :

   udhcpc -b -T 1 -A 12 -i <interface eth0 or eth1 ussually>

   Posted 11 years ago #

RSS feed for this topic

Reply

You must log in to post.