resolved
Ignasi
offlineMember
Hey, I just installed slitaz on my laptop.
The issue is, during boot, it takes a lot on the following step:
Configuring wlan0...
where a lot of time is almost a minute
I've tried setting WIFI="no" in /etc/network.conf but this only changes from "Configuring wlan0" to "Configuring eth0" and still takes the same amount of time.
I've heard about boot scripts in /etc/init.d but I'm not really sure how to deal with that.
Any help will be appreciated.
Thanks guys : )
mojo
offlineKey Master
/etc/rcS.conf is the main configuration file for loading daemons,scripts,modules,etc..
http://mirror.slitaz.org/hg/hgwebdir.py/slitaz-boot-scripts/file/a6d3a3585e91/etc/rcS.conf
Stop network.sh from autostarting on boot:
Remove network.sh from RUN_SCRIPTS=
Stop/Start network.sh manually from console:
#/etc/init.d/network.sh stop|start
More Info:
http://mirror.slitaz.org/doc/en:guides:network-script
http://mirror.slitaz.org/doc/en:handbook:start
Ignasi
offlineMember
Thank you for your quick answer! : )
It worked perfectly, now booting with 5 seconds instead of the 69 before = ='
Just 1 comment, first I tried what you said, of removing network.sh from RUN_SCRIPTS in /etc/rcS.conf
And it worked, just I didn't had hostname... (in terminal I was shown as: username@(none) )
So I put back the network.sh in RUN_SCRIPTS, and in /etc/init.d/network.sh I commented the start call in line 202 (the one after the boot call)
Thank you again.
You must log in to post.
