SliTaz Forum

Detecting and setting audio drivers

(5 posts) (3 voices)

• Started 10 years ago by arodulfo
• Latest reply from Sam
• This topic is not resolved

Tags:

No tags yet.

1. 

   arodulfo
   

   offline

   Member

   Dear all,

   Our installation and our application run comfortably on the SBC we have been dealing with since the very beginning. It uses and HDA Intel audio device.

   Quite recently, our customer came to us claiming they have some older displays and that they wanted them also integrated into the system. To our surprise, everything works well... but the audio.

   Even if we're sure all the AlsaMixer settings are properly set to their maximum, no sound comes out of the older SBC we have as a sample of what we have to deal with.

   I have two questions: according to your experience, which is the best approach to (1) detect the audio device in the system and (2) apply the proper settings.
   By issuing the command lspci | grep Audio in the system which dose output sound, I get the following result:
   00:1B.0 Audio device: Intel Corporation N10/ICH 7 Family High Definition Audio Controller (rev 02)

   Provided that I can get the older SBC up and running, I'll issue the same command and will post the result here. As far as I know, on the other hand, it is using PCH7 audio.

   Kind regards,
   Antonio

   Posted 10 years ago #
2. 

   arodulfo
   

   offline

   Member

   I forgot to apply some tags so that the post would be easy to organize...

   Posted 10 years ago #
3. 

   arodulfo
   

   offline

   Member

   Dear all,

   Here's another test I did, following other posts I've read in this forum:

   Command: aplay -l

   Result:
   

   **** List of PLAYBACK Hardware Devices ****
   card 0: Intel [HDA Intel], device 0: ALC662 rev1 Analog [ALC662 rev1 Analog]
     Subdevices: 1/1
     Subdevice #0: subdevice #0

   I hope it helps.
   Kind regards,
   Antonio

   Posted 10 years ago #
4. 

   kultex
   

   offline

   Key Master

   see if one of this threads helps - very often a aplay problem

   http://vanilla.slitaz.org/index.php?p=/discussion/1160/solved-problem-with-sound-card-via-vt8237-module-snd_via82xx-duplicate-front-option/p1

   http://vanilla.slitaz.org/index.php?p=/discussion/comment/9484

   slitaz is not using alsaconf - it was rewritten - soundconf - you can run it as root and select your sondcard

   Posted 10 years ago #
5. 

   Sam
   

   offline

   Member

   Hello,

   (i m not an advanced user)

   I installed Slitaz on a IBM T40 (256 MB RAM), and it runs so good.
   But i have no sound.
   I saw here http://www.linlap.com/ibm-lenovo_thinkpad_t40
   that i have to use the snd-intel8x0 module.
   I can see it when with
   modprobe -l | grep snd-intel

   But if i run soundconf (as root) it fails to detect a sound card.
   Also lspci | grep Audio does not return nothing
   and aplay -l return no sound card found

   Is there any easy solution to set my soundcard.

   Thanks
   Sam

   Posted 10 years ago #

RSS feed for this topic

Reply

You must log in to post.