Dear all,
I am using an iEi WAFER-945-GSE SBC, tied to n 800x600 LCD monitor.
The SBC has a couple of ethernet sockets and one of them was properly set up as eth0 during install.
Would it be possible to set the second interface (eth1
) as well?
If so, where should I start looking for help?
I tried to look for /etc/network/interfaces
in order to allow this interface activation, but the file is not there!
I found eth0
being provided for in /etc/network.conf
.
However, there seem to be no room for a second interface definition.
I had a look at /etc/init.d/network.sh
as well.
It just refers to ONE interface (the one you find in /etc/network.conf
, I guess).
I'm quite sorry. I tried to do my homeworks...
Thanks a lot for your time.
Kind regards,