SliTaz Forum

lexeii

Administrator

Registered: 2012-03-21

Posts: 1,853

Segfault in Inkscape

Can anyone confirm that?

When I run inkscape in the terminal, I get only short message "Segmentation fault". While inkscape still can working without GUI, for example I can convert svg to png using command line.

Re-cooking not helps, segfault still here. Strace command not helps me to debug it...

I not used inkscape for a several months, but if my memory serves me right, it works well at the year's beginning in the SliTaz Rolling.

mojo

Administrator

Registered: 2011-03-29

Posts: 2,174

Re: Segfault in Inkscape

I confirm segfault on up to date rolling full install.

Debug info: https://inkscape.org/en/develop/debugging/

lexeii

Administrator

Registered: 2012-03-21

Posts: 1,853

Re: Segfault in Inkscape

Thank you, Richard!

Found that problem is somewhere in the pango package.

Also, Alexander a.k.a. az_ua reported that Inkscape works with SliTaz RC2.

mojo

Administrator

Registered: 2011-03-29

Posts: 2,174

Re: Segfault in Inkscape

I confirm your diagnosis of the problem.

Inkscape runs on updated cooking after installing repacked pango-1.30.1.tazpkg from RC2.