SliTaz Forum

searchfgold6789

Member

Registered: 2011-09-13

Posts: 41

Can't get wired internet to work

Hi,

For some reason, when I start SliTaz with the ethernet cable plugged in, it won't connect. I open the network settings, and it says that 'lo' is connected but 'eth0' and 'eth1' have no info attached to them. I cannot open web pages,

Any clues?

mojo

Administrator

Registered: 2011-03-29

Posts: 2,174

Re: Can't get wired internet to work

Slitaz has detected 2 ethernet adapters (eth0 and eth1)

Ignore lo it is the software internal loopback.

The default network script can only support 1 hardware network adapter and is set to eth0.

Maybe the ethernet cable connected to your modem is connected to eth1.

Switch your eternet cable to the other ethernet adapter.

Restart network in xterm:

su password: root

/etc/init.d/network.sh stop

/etc/init.d/network.sh start

Copy/paste output from terminal if it fails to connect.

Post which version of slitaz you're using.

searchfgold6789

Member

Registered: 2011-09-13

Posts: 41

Re: Can't get wired internet to work

I did [c]/etc/init.d/network.sh restart[/c] as suggested, found out that it was configured to automatically connect via the wrong connection (eth0 rather than eth1) and so I changed this in my network setting file. Thank you!!

mojo

Administrator

Registered: 2011-03-29

Posts: 2,174

Re: Can't get wired internet to work

Your welcome