help, Install "SliTaz 4.0-RC3" in console mode

Guest · 2012-04-03 00:51:24

Hi, I wonder if there is a manual or tell me how to install "SliTaz 4.0-RC3" and "grub" through the console mode.

mojo · 2012-04-03 01:01:31

Frugal Install with grub

tazusb: http://hg.slitaz.org/tazusb/raw-file/tip/doc/tazusb.en.html

Full Install with grub

tazinst : http://hg.slitaz.org/slitaz-tools/raw-file/6e8c38a0aee3/doc/tazinst.en.html

From console:

tazusb usage

tazinst usage

Do not use fat32 or NTFS filesystems on full install partition or for /home partition, only linux ext3 filesystem.

Guest · 2012-04-03 01:25:57

I get this error:

[attachment=8484,401]

mojo · 2012-04-03 02:45:33

You have to manually configure the Slitaz installer setup file /var/lib/tazinst.conf

#nano /var/lib/tazinst.conf

The setup file is well commented with examples.

http://hg.slitaz.org/slitaz-tools/raw-file/6e8c38a0aee3/doc/tazinst.en.html : SETUP FILE

Finish and save tazinst.conf in nano, run tazinst check /var/lib/tazinst.conf

After tazinst check validates tazinst.conf, your ready to install.

#tazinst install /var/lib/tazinst.conf

Guest · 2012-04-03 09:36:59

and I did well, it was my fault that I read the wrong manual command.

thanks for the help

SliTaz Forum