SliTaz Forum

terrybull

Member

Registered: 2011-11-06

Posts: 127

Touch Screen Panasonic cf-28 calibration

I've got Slitaz 5 rolling installed on my Toughbook CF-28. The touch screen works out the box but is way out of calibration. I downloaded the screen calibration tool but when I open it it gives this error

Cannot parse command line arguments

I'm not sure what graphics driver is in use Xorg etc.

Any help please.

Thanks

terrybull

Member

Registered: 2011-11-06

Posts: 127

Re: Touch Screen Panasonic cf-28 calibration

Hi. Just trying a 'bump' on this. Can anyone suggest a way foreward or where to look. I am totally stuck on this issue. Note my Linux skill is very basic.

Thanks

gibor

Moderator

Registered: 2011-04-30

Posts: 1,067

Re: Touch Screen Panasonic cf-28 calibration

Hi terrybull, try to launch on terminal

type exactly (or copy and paste)  xinput_calibrator

terrybull

Member

Registered: 2011-11-06

Posts: 127

Re: Touch Screen Panasonic cf-28 calibration

Thank you gibor. Fantastic. Launches the calibrator. It is not calibrating perfectly and remains a little out at the extreem edges but its quite useable so thanks. I think I have to save the configuration file to save these settings on reboot. Any help on how to do this appreciated.

terrybull

Member

Registered: 2011-11-06

Posts: 127

Re: Touch Screen Panasonic cf-28 calibration

I managed to sort this out and the screen calibration remains correct after re-boots.