SliTaz Forum

sevac

Member

Registered: 2012-06-17

Posts: 13

Usb to uart bridge controller

Is there no cp210x driver usb to uart in slitaz?

cat /proc/bus/usb/devices

T:  Bus=05 Lev=01 Prnt=01 Port=01 Cnt=01 Dev#=  2 Spd=12   MxCh= 0

D:  Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=64 #Cfgs=  1

P:  Vendor=10c4 ProdID=ea60 Rev= 1.00

S:  Manufacturer=Silicon Labs

S:  Product=CP2102 USB to UART Bridge Controller

S:  SerialNumber=0001

C:* #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=100mA

I:* If#= 0 Alt= 0 #EPs= 2 Cls=ff(vend.) Sub=00 Prot=00 Driver=(none)

E:  Ad=81(I) Atr=02(Bulk) MxPS=  64 Ivl=0ms

E:  Ad=01(O) Atr=02(Bulk) MxPS=  64 Ivl=0ms

gibor

Moderator

Registered: 2011-04-30

Posts: 1,067

Re: Usb to uart bridge controller

The kernel module is not enabled

# CONFIG_USB_SERIAL_CP210X is not set

recompile with

CONFIG_USB_SERIAL_CP210X = m

To recompile kernel find the complete procedure on forum, or read my experience on italian forum

http://forum.slitaz.org/topic/ftdi-adattatore-rs232-usb#post-1285