SliTaz Forum

panoskrt

Member

Registered: 2011-08-23

Posts: 3

Networking bridging (br0)

Hi all. I have been trying to find in the SliTaz documentation as well as in this forum some information on how a bridge network can be set up in SliTaz, but no luck. Are there any istructions how? /etc/network.conf doesn't given any hints either.

Any help would be much appreciated!

panoskrt

Member

Registered: 2011-08-23

Posts: 3

Re: Networking bridging (br0)

Dissapointing no replies to this one. I had to edit udev rules and get eth0 renamed to br0 to get the job done.

mishaparem

Member

Registered: 2013-04-22

Posts: 4

Re: Networking bridging (br0)

Hello everyone, sorry for the necro. I am trying to do the exact same thing, but I am obviously not as experienced as the OP. I found the /etc/udev/rules.d/ directory, but I can't find eth0 in any of the files. I suspect I would handle it in 75-net-description.rules or *MAYBE* in  50-udev-default.rules, but could someone explain to me how renaming an interface changes it's properties, and how I would go about renaming it in the udev rules? so far I just found information similar to, "find the line with eth0 in it, and rename eth0 to br0".

Thanks,

Misha

Guest

Guest

Re: Networking bridging (br0)

This post 'might' help :-

http://forum.slitaz.org/topic/bridging-networks