SliTaz SliTaz Forum archive

This forum is now a read-only archive

The SliTaz community has moved to Maille, a forum made for SliTaz.

We looked hard for a replacement for this aging forum, including a move from bbPress to FluxBB last June. But spam bots now get through sign-up even with mail confirmation, and these forum engines are barely maintained anymore. So we wrote a forum in the SliTaz spirit: small, fast, no JavaScript, works on old machines and in text browsers. Everything here stays readable.

Go to Maille

You are not logged in.

Pages: 1

#1 2012-11-28 16:01:12

datto
Member
Registered: 2012-11-26
Posts: 6

"tazhw setup ati" set the driver to "nv"

Hi all,

On a 4.0 stable when I run "tazhw setup ati", it creates a 55-DeviceTweaks.conf with Driver="nv".

I was following the instructions from http://doc.slitaz.org/en:guides:xorg-xvesa. Apparently this document was created in 3.0. Not sure if it is still applicable for 4.0...

If I change nv to ati or radeon, everything works fine. By the way, what is the difference between ati and radeon (I have a old Radeon Mobility 7500 - M7 LW).

Regards,

Datto

Offline

Pages: 1

Registered users online in this topic: 0, guests: 1
[Bot] ClaudeBot

Board footer

Powered by FluxBB
Modified by Visman

[ Generated in 0.017 seconds, 7 queries executed - Memory usage: 1.53 MiB (Peak: 1.77 MiB) ]