SliTaz Forum

subreptice

Member

Registered: 2013-03-10

Posts: 54

Trying to tazpkg set-release cooking

Hello.

I had an up-to-date and working slitaz4,

and I have tried to :

tazpkg set-release cooking

a lot of time, but it always ending wrong ...

I'm starting the process with something like 130 free Mo on the "hdd";

after the not-so-good install (a lot of stuffs are broken), I still have free space;

I have at least 512 of ram on this machine;

I put the whole output of Sakura later, when it will work, answering myself.

Do you think it is a problem of space disk : there is not enough to begin a set-release ?

-----

Bonjour.

Je ne parviens pas à passer avec succès, d'une Slitaz4 à une Cooking, avec la commande tazpkg set-release cooking;

J'ai 130 Mo de libres sur le disque avant de lancer le processus et il reste de l'espace quand il finit;

il y a au moins 512 de ram sur ces machines;

j'ai copié-collé la sortie sur sakura en pj, mais ça marche pas (?!) donc je joindrais plus tard ...

J'ai pas assez d'espace disque ou le problème est ailleurs ?[attachment=24905,1119]

mojo

Administrator

Registered: 2011-03-29

Posts: 2,174

Re: Trying to tazpkg set-release cooking

There are too many differences to hope for a working system by updating a slitaz 4.0 install with the packages from pre-5.0 cooking repo. If you want to try cooking use the rolling iso.

subreptice

Member

Registered: 2013-03-10

Posts: 54

Re: Trying to tazpkg set-release cooking

Ok, thanks mojo !

The only acces on those thin client is to boot on usb, and after, make an install from that session, so they become "full light cheap personnal computer";

so, I can run a fresh live slitaz5(burned from .iso), and make from/with it a bootable key, and it could works ? Right ?

subreptice

Member

Registered: 2013-03-10

Posts: 54

Re: Trying to tazpkg set-release cooking

...yes it works fine :-)

I now have a slitaz rolling usb :-)

For now, I can't get rolling installed from usb to hdd with tazpanel, but I must try again.

Thanks all !